- Contents in this wiki are for entertainment purposes only
Field Array Pulse Injector: Difference between revisions
XenoEngineer (talk | contribs) |
XenoEngineer (talk | contribs) No edit summary |
||
| Line 1: | Line 1: | ||
{{S100DivOpen}} | |||
{{headerFieldArray}} | {{headerFieldArray}} | ||
=== NanoBolt Field Array Driver === | === NanoBolt Field Array Driver === | ||
[[File:Pulse injector concept 800x563.png|left|500px|thumb|Schematic 1. The basic principle of NMR resonance is to create a background magnetic flux in copper resonator element with a steady direct electrical current (D.C.) into a resonator (load) element. A fast blocking diode (D1) allows a higher voltage pulse 'injected' into the load circuit connected at J3, between the blocking diode and the resonator element. In NMR jargon, J1 signal injects a B1 pulse-train over the B0 nuclear spin precessing flux created by current through J2.]] | [[File:Pulse injector concept 800x563.png|left|500px|thumb|<font color="gray">Schematic 1. The basic principle of NMR resonance is to create a background magnetic flux in copper resonator element with a steady direct electrical current (D.C.) into a resonator (load) element. A fast blocking diode (D1) allows a higher voltage pulse 'injected' into the load circuit connected at J3, between the blocking diode and the resonator element. In NMR jargon, J1 signal injects a B1 pulse-train over the B0 nuclear spin precessing flux created by current through J2.</font>]] | ||
[[File:EPC2022 to TO-220 footprint adaptor.jpg|right|400px]] | [[File:EPC2022 to TO-220 footprint adaptor.jpg|right|400px]] | ||
| Line 20: | Line 21: | ||
</html> | </html> | ||
</div> | </div> | ||
{{S100DivClose}} | |||
Revision as of 11:05, 30 September 2023
NanoBolt Field Array Driver
In the Field Array prototype designs, transistor Q1 in Schematic 1 is replaced with quantum-enhanced FET technology (eGaN) by EPC (EPC2022).
To best appreciate the switching speed of the eGaN, the circuit must be optimized to minimum inductance. The design facilitates optimized low-inductance for higher frequency operation of the switches when configured in a Resonant-X configuration (prototype chaotic power-logic-ring oscillator), by embedding the adaptor board of Illus. 1 within a solid copper conductor of sufficient diameter to allow a hollow center for connecting the circuit to the power stud, and receiving B0 current. Also on the body of the stud is a connector receiving the switching signal, which routes to the eGaN gate through the adaptor.
Please standby for further open-sourced development. XenoEngineer —research and development by a talking simian 10:53, 30 September 2023 (UTC)
