D. Edward Mitchell 16:00, 14 April 2020 (UTC) Hello World! groupKOS Developer Share —usually UNDER CONSTRUCTION
Vector Inversion Autotransformer
- Matching meaning to — novel principle of transient high voltage
A vector inversion autotransformer is detailed in Appendix C of Streamer Chamber Development, 1967 SLAC Report No. 74., Stanford Linear Accelerator Center, Stanford Uni., Standford, California. "This is a technical report prepared under contract AT(04-3)-515 for the USAEC, San Francisco Operations Office"
This device was built in a study to condition the pulse discharge of a Marx spark-gap generator, which was then feed to a plasma chamber to ignite a two-meter plasma streamer.
This device is ironless. It consists of copper foil (2-5 thousandths), with polyethylene or mylar, also rolled with toilet paper vacuum-impregnated with CuSO4 solution. The layers are wound on a Lucite(R) cylinder.
"[...] The streamer chamber program carried out by Drs. D. Benaksas and R. Morrison at Stanford has provided us with the reassuring information that it is possible to operate streamer chambers in high magnetic fields and that it is practical to use these chambers in the photon beams produced by electron linacs."
- Appendix C
"The copper sulfate* has the important function of distributing the field smoothly at the edges of the copper winding so that breakdown through the insulating sheets does not occur. [...] * The resistivity of the copper sulfate solution should be of the order 104 ohm-cm."
A Blumlein line is also mentioned in Appendix C as sometimes the load of the autotransformer output, which is a bank of dielectric storage banks that can be switched to charge in parallel and discharge in series (like the Marx spark-gap pulse generator).
Source SLAC Report:
- F. Bulos, A. Odian, F. Villa, and D. Yount
- June 1976
- DOI: 10.2172/4271590
- PDF: https://www.osti.gov/servlets/purl/4271590
- Streamer chamber development SLAC report no. 74, June 1976 4271590.pdf